Specification
1.Works with standard (dual 5/3.3V) and 3.3V-only (for example, Arduino Pro)boards.
2.Operates over the extended -40°C to +85°C temperature range
3.Complies with USB Specification Revision 2.0 (Full-Speed 12Mbps Peripheral,
4.Full-/Low-Speed 12Mbps/1.5Mbps Host)
Specification
1.Works with standard (dual 5/3.3V) and 3.3V-only (for example, Arduino Pro)boards.
2.Operates over the extended -40°C to +85°C temperature range
3.Complies with USB Specification Revision 2.0 (Full-Speed 12Mbps Peripheral,
4.Full-/Low-Speed 12Mbps/1.5Mbps Host)
The following device classes are currently supported by the shield:
4. HID devices, such as keyboards, mice, joysticks, etc.
5.Mass storage devices, such as USB sticks, memory card readers, external hard drives (FAT32 Type File System – Arduino Mega only)
primary info
penetrating ability SI4432 IC, stable performance
Frequency Range: 433.92M
Sensitivity up to-121dBm
Maximum output power: 20dBm
Data transfer rate :0.123-256kbps
FSK, GFSK and OOK modulation mode
1.8-3.6 V power supply
Low consumption shutdown mode
Digital received signal strength indicator (RSSI)
Timing wake-up function
The antenna automatically match and two-way switch control
Parameters:
PCB Dimensions: 26.5* 15.6mm
With 3.3V and 5V dual power output
With three LEDs: power indicator, data reception indicator, the data transmission indicator, working status
With self-recovery fuse. In the event of accidental short circuit, it can effectively protect your computer USB port and Downloader
With reset signal output, etc. directly to the for Arduino board Promini download!
Audio Input: Wireless Bluetooth
Max. Receiving Distance: 10 Meter
Power Output: Dual-channel 15 W+15 W
Applicable Speaker Impedance: 4/6/8/10 ohm
Supply Voltage: DC 10~25 V(recommended DC 12V More than 2A)
Description
With this Ethernet Shield, your Arduino board can be used to connect to internet.
Can be used as server or client.
Directly plug puzzle board, no soldering required.
Controller: W5100.
This Arduino Ethernet Shield which is based on the Wiznet W5100 Ethernet Chip gives you an easy way to get your Arduino Online.
It is directly supported by Arduino official Ethernet Library.
Specification:
* Quad-Band 850 / 900/ 1800 / 1900 MHz - would work on GSM networks in all countries across the world.
* GPRS multi-slot class 10/8
* GPRS mobile station class B
* Compliant to GSM phase 2/2+
* Class 4 (2 W 850 / 900 MHz)
* Class 1 (1 W 1800 / 1900MHz)
The HC-05 bluetooth module can be set as a transmitter or receiver. You can combine this bluetooth module with your system: MCU, ARM or DSP systems, SOC systems.
This module can build a connection to other modules in two ways: as a master or as a slave. Ex, a robot can be designed to be a master connected to a slave bluetooth module or as a slave board to make a wireless connection with a PC.
Module stereo output, built-in Bluetooth antenna structure is simple, the power supply voltage is 3.7V~5V version selection, active speakers increase Bluetooth connection function. 7PIN output interface is spacing 2.54 through hole, 7PIN output interface is: + power, ground, left channel, right channel, mute, LED status indicator, reserved port.