Features:
Brand new and high quality
Designed with an advanced switch mode DC-DC regulator IC
The output is powerful even working with 4 to 6 cells Lipo battery
Battery polarity reversal protection
Item: 3A-UBEC
Features:
Brand new and high quality
Designed with an advanced switch mode DC-DC regulator IC
The output is powerful even working with 4 to 6 cells Lipo battery
Battery polarity reversal protection
A metal shield covers almost all the electronic components, and a specially made filter is
attached with the output wires to significantly reduce the electromagnetic interference
The working status is shown by an indicator (LED), lights when the output is in normal range
Item: 3A-UBEC
Output Voltage: 5V or 6V (Changeable with an output-voltage select switch )
Continuous output current: 3 Amps
Input: 5.5V-26V (2-6 cells lithium battery pack or 5-18 cells NiMh /NiCd battery)
Size: 42mm (L) * 24mm (W) * 11mm (H)
Advantages:
The 3A-UBEC is a switch-mode DC-DC regulator supplied with a 2-6 cells lithium battery pack (or 5-18 cells NiMh /NiCd battery ) and it outputs a consistent safe voltage for your receiver, gyro and servos. It is very suitable for RC helicopter.
Compared with the linear mode UBEC, the overall efficiency of the switch-mode UBEC is higher.
01, on-board precision miniature voltage transformer
02, on-board high-precision op amp circuit, the signal to do accurate sampling and appropriate compensation function
03, the module can measure less than 250V AC voltage, corresponding toExportAnalog can be adjusted
04, PCB board size: 49.5 (mm) x19.4 (mm)
01. Input: DC 6V - 12V (input voltage to output voltage must be greater than 1V or more.)
02. Output: 5.0V (+-0.05v error), 800mA (load current must not exceed 800ma)
03. pairs of panel design, layout, nice;
04. specially designed two pin mounting holes, can be directly fixed on the hole expansion board for experiments;
05. Input Output Using 2P single row pin header for easy connection;
06. PCB board size: 2.5cm * 1.1cm
07. with power indicator light (red)
Specification:
1. This item is a 5V 8-Channel Relay interface board,It can be controlled directly by a wide range of microcontrollers such as for Arduino, AVR, PIC, ARM and so on.
2. 8-Channel Relay interface board.
3. Each one needs 15-20mA Driver Current.
4. Equiped with high-current relay : DC30V 10A AC250V 10A.
Description
* on-board AMS1117-3.3 chip
* the input voltage range of 4.75V-12V
* on-board power indicator light, indicate power is turned
* board size: 18.5 (mm) x10.5 (mm)
input voltage: DC 3 V to 6 V
Input current: 2 A - 5 AHigh pressure type: the type of pulse current
Output voltage: 400000 v(Please pay attention to safety)
High pressure discharge distance between: 10 mm - 20 mm
The output high voltage wire length: 100 mm
Input power cord length: 100 mm (the red line is positive)
Wiring:
Red and green power connection red line:"+" green line "-"
output : the other side ,same color cable
