the maximum current of 2.5A.
the maximum support 32 subdivision.
4 layer PCB board, better heat dissipation.
the chip resistance is smaller, lower heat, better heat dissipation.
A simple steps and direction control interface
six different steps resolutions: full step, half step, 1/4-step1/8-step1/16-step, 1/32-step
CAN interface directly with 3.3 V and 5 V systems
Over-temperature thermal shutdown, overcurrent shutdown, undervoltage lockout
short to ground short circuit load protection
4 Layer 2 oz copper PCB, in order to improve heat dissipation
exposed solder ground below the bottom of the driver IC on the printed circuit board pad
module size, pin and interface matching A4988 stepper motor driver operators in many ways
adjustable current control lets you set a potentiometer, which lets you use the stepper motor’s rated voltage or more, in order to achieve a higher rate of maximum output current step
Intelligent chopping control automatically selects the correct current decay mode (fast decay or slow decay)
Maximum 45 V supply voltage
built-in voltage regulator (the need for any external logic supply voltage)
01. Weight : 13.6G
02. Dimension : 22.8mm x 12.2mm x 28.5mm
03. Stall Torque : 1.8kg/cm(4.8V )2.2kg/cm(6V)
04. Temperature Range : 0 degree to 55 degree
05. Operating Speed :Â
06. 0.1sec/60degree(4.8v),0.08sec/60degree(6v)
07. Dead Band Width : 5 usec
08. Operation Voltage : 4.8 - 6Volts
09. Operating torque: 2KG/cm
10. servos Type : Digital servo
11. Gear Type : All Metal gear
12. Plug Type :JR FUTABA
13. structural materials: Metal gear Coreless Motor DUAL BALL Axle Bearing
These black plastic wheels are designed specifically for use with our FEETECH FS90R Servo. The wheels have silicone tires and measure 60 mm (2.36?) in diameter.Four additional mounting holes for 4-40 screws make it possible to use the wheel with several of our universal mounting hubs.
Material: brass
Inner diameter: 2/4/5/6/7mm
Hexagon side length: 7mm
Diagonal distance: 13.6mm
Distance across flat: 12mm
Total height: 18mm
Cylinder part height: 12mm
Out diameter of cylinder part: 11mm