1. Support the full range of STM32 SWD interface debugging, simple interface (including power supply), 4 line speed, stable work; Interface definition shell directly address! Don\’t need to read instructions!
2, support all series STM8 SWIM download debugging (common development environment such as IAR, STVD etc.) are supported. Support the software version is as follows:
ST – LINK Utility 2.0 and above
STVD 2 and above
STVP 3.2.3 and above
IAR EWARM V6.20 and above
IAR EWSTM8 V1.30 and above
KEIL RVMDK V4.21 and above
3. Support the firmware upgrade automatically, to ensure that the ST company product support. When they leave the firmware has been upgraded to the latest V2. The J17. S4.
4. Increase the 5 v power output, the output it can protect the I/O port, not afraid of error cause damage of ST – LINK V2!
5. Easy interface to use pure copper plating 2.54 spacing horn, with 20 cm dupont line, can deal with different target board line sequence, flexible connection;
6. Use U disk aluminum alloy shell to protect the mainboard, convenient to carry, not afraid of static electricity, not afraid of tumbling.
1 single module can drive the an 8 * 8 dot matrix common cathode
2 the module Operating voltage: 5 v
The Module 3 dimensions: length 3.2 cm X 3.2 cm wide X 1.3 cm high
4 holes with four screws, the diameter of 3 mm
This is a terminal adapter for the for arduino Nano.
It lables for arduino Nano version 3.0,
however you can still use this adapter for the older version
(just have to remember that A0-A7 are in the reverse order).
You can use this adapter to easily hook up for arduino Nano to an outside world via hook up wires.
Board Size:5.2x3.5cm(approx)
ATmega168 running at 16MHz with external resonator
USB connection off board
Supports auto-reset
Max 150mA output
Over current protected
Reverse polarity protected
DC input 5V up to 12V
On board Power and Status LEDs
Size:(Long)33mm *(wide1)18 mm *(high)6mm
Package Content
1PCS Arduino pro min atmega168p board
3PCS Gilded Pin
Technical details:
Nano V3 form-factor,
ATmega168 (16Mhz) microcontroller,
CH340G - USB-UART interface,
Input voltage 6-12V,
Output voltage 5V/800mA, 3.3V/180mA (Only in NEW vesrion),
MicroUSB - connection socket,
500mA resetable Fuse on USB port
Input Voltage: 5V DC
Output Voltage: 1.9~3.6 DC
Current: 12.3 mA
Adapted for 8 Pin NRF24L01+ Module
On-board AMS1117-3.3 chip
Dimension: 26 x 19 x 12mm