Specification:
1. This item is a 5V 8-Channel Relay interface board,It can be controlled directly by a wide range of microcontrollers such as for Arduino, AVR, PIC, ARM and so on.
2. 8-Channel Relay interface board.
3. Each one needs 15-20mA Driver Current.
4. Equiped with high-current relay : DC30V 10A AC250V 10A.
Specification:
1. This item is a 5V 8-Channel Relay interface board,It can be controlled directly by a wide range of microcontrollers such as for Arduino, AVR, PIC, ARM and so on.
2. 8-Channel Relay interface board.
3. Each one needs 15-20mA Driver Current.
4. Equiped with high-current relay : DC30V 10A AC250V 10A.
5. Each relay has normally open and normally closed contact.
6. The 8 channels are optically isolated, safe, reliable, anti-interference.
7. Can be selected by jumper relay and TTL or ground.
8. With power indicator,8-way road has a status indicator.
9. With a relay coil to absorb the diode protection.
10. The circuit board size 140mm X 55mm
11. Mounting hole size 133mm X 40mm
coil rated voltage : 5V
Rated Load: 10A 250VAC, 10A 30VDC
Max Switching Current: 10A
Max Switching Voltage: 110VDC / 250VAC
Coil power 0.45W
Contact Arrangement: C:1 (NO/NC)
Dimensions: 19 x 15 x 15 mm
SDIO 2.0, SPI, UART
32-pin QFN package
Integrated RF switch, balun, 24dBm PA, DCXO, and PMU
Integrated RISC processor, on-chip memory and external memory interfaces
Integrated MAC/baseband processors
Quality of Service management
I2S interface for high fidelity audio applications
On-chip low-dropout linear regulators for all internal supplies
Proprietary spurious-free clock generation architecture
Integrated WEP, TKIP, AES, and WAPI engines
Solutions
Supports APSD for optimal VoIP applications
Patented spurious noise cancellation algorithm for integration in SOC applications
Supports Bluetooth co-existence interface
Self-calibrated RF to ensure optimal performance under all operating conditions
Zero factory tuning
No external RF components
Specifications
802.11 b/g/n
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Integrated TR switch, balun, LNA, power amplifier and matching network
Integrated PLLs, regulators, DCXO and power management units
+19.5dBm output power in 802.11b mode
Power down leakage current of <10uA
Integrated low power 32-bit CPU could be used as application processor
SDIO 1.1/2.0, SPI, UART
STBC, 1×1 MIMO, 2×1 MIMO
A-MPDU & A-MSDU aggregation & 0.4ms guard interval
Wake up and transmit packets in < 2ms
Standby power consumption of < 1.0mW (DTIM3)
Product parameters:
* H bridge motor dual drive, and can drive two DC motor or 1 line 4 phase stepper motor;
* The voltage of the power supply module 2V-10V;
* The signal input voltage 1.8-7V;
* Single channel current of 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA);
Module stereo output, built-in Bluetooth antenna structure is simple, the power supply voltage is 3.7V~5V version selection, active speakers increase Bluetooth connection function. 7PIN output interface is spacing 2.54 through hole, 7PIN output interface is: + power, ground, left channel, right channel, mute, LED status indicator, reserved port.
