1. 5V 2-Channel Relay interface board, and each one needs 15-20mA Driver Current, optocoupler isolation.
2. Equiped with high-current relay, AC250V 10A ; DC30V 10A
3. Standard interface that can be controlled directly by microcontroller
Description:
This is a 2-Channel Relay interface board, which can control various appliances, and other equipments. It can be controlled directly by Microcontroller.
Rated voltage: DC12
Rated current: 10A
Coil power: 0.36W
Contact switch voltage: 220VAC
Protective characteristics: Sealed
Contact load: Medium-power
Application: Electromagnetism
Contact Form: Conversion type
With 4 mounting holes, diameter of each hole is 3.1mm, easy to install
Apply superior SONGLE relay, SPDT(single-pole double-throw), one common port, one NO and one NC
Opto-isolator, excellent anti-interference performance
Low level actuation(indicator ON), high level release(indicator OFF)
Maximum output of relay: DC 30
Size: As the picture show
Product parameters:
* H bridge motor dual drive, and can drive two DC motor or 1 line 4 phase stepper motor;
* The voltage of the power supply module 2V-10V;
* The signal input voltage 1.8-7V;
* Single channel current of 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA);
the use of solid state relays, output with a resistive fuse 240V 2A.
Size: 55 * 33 * 25 (L * W * H)
input power: 5V DC (160MA)
the input control signal voltage:
(0-1.5V state low level relay ON)
(2.5-5V state high level relay OFF)
blue KF301 terminal access control line more convenient
SDIO 2.0, SPI, UART
32-pin QFN package
Integrated RF switch, balun, 24dBm PA, DCXO, and PMU
Integrated RISC processor, on-chip memory and external memory interfaces
Integrated MAC/baseband processors
Quality of Service management
I2S interface for high fidelity audio applications
On-chip low-dropout linear regulators for all internal supplies
Proprietary spurious-free clock generation architecture
Integrated WEP, TKIP, AES, and WAPI engines
Solutions
Supports APSD for optimal VoIP applications
Patented spurious noise cancellation algorithm for integration in SOC applications
Supports Bluetooth co-existence interface
Self-calibrated RF to ensure optimal performance under all operating conditions
Zero factory tuning
No external RF components
Specifications802.11 b/g/n
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Integrated TR switch, balun, LNA, power amplifier and matching network
Integrated PLLs, regulators, DCXO and power management units
+19.5dBm output power in 802.11b mode
Power down leakage current of <10uA
Integrated low power 32-bit CPU could be used as application processor
SDIO 1.1/2.0, SPI, UART
STBC, 1×1 MIMO, 2×1 MIMO
A-MPDU & A-MSDU aggregation & 0.4ms guard interval
Wake up and transmit packets in < 2ms
Standby power consumption of < 1.0mW (DTIM3)
Module stereo output, built-in Bluetooth antenna structure is simple, the power supply voltage is 3.7V~5V version selection, active speakers increase Bluetooth connection function. 7PIN output interface is spacing 2.54 through hole, 7PIN output interface is: + power, ground, left channel, right channel, mute, LED status indicator, reserved port.