Features:
1.Low voltage, low power device, and with automatic power off switch.
2.3 wire interface can meet the various communication with the microprocessor.
3.Compared with MS5534A, the pressure range of the pressure drop (10 mbar) is improved.
01. This charger can charge 2/4/6/8 pcs AA/AAA Ni-MH/Ni-Cd rechargeable batteries.
02. Timer controls the charging process.Insure using safety.
03. LED in luminous when charging ,will turn off when batteries are fully charged .
04. The constant current and voltage will prolong battery life.
Specification:
Input: 100-240V 50/60Hz
Output: 2.4V DC 600mA
AA 150mA * 2 (or 4, 6, 8)
AAA 100mA * 2 (or 4, 6, 8)
Features:
Name: electronic compass atmospheric pressure module (three-axis magnetic field + pressure)
Model: GY-652
The use of chip: HMC5983 + BMP180
Power supply :3-5v (internal low dropout regulator)
Communication modes: standard IIC communication protocol)
Feature:
The Standard 2.4Ghz 3-Channel Receiver for RC car and boat.
Compatible with FS 2.4Ghz Surface Transmitter, very easy to bind.
Channels: 3 channels
Model type: Car/Boat
Modulation: GFSK
Code type: PPM
Frequency: 2.4G
Certificate: CE FCC
01. Rated Voltage:DC 12 V
02. Speed : 100 RPM
03. Shaft Diameter : 3 mm
04. Size:Diameter: 12 mm
05. fuselage without shaft length: 26 mm
06. Output axial length: 10 MM to 4.4 MM
07. Name:DC Mini Metal Gear Motor.
08. Voltage range:6-12V
1. 3v-5v voltage available
2. Type: GY-GPS6MV2
3. With ceramic antenna, the signal is strong
4. EEPROM save configuration parameter data when power supply drop
5. Data backup battery
6. LED signal lights
7. Default baud rate: 9600
01. 2 interface for 5V Servo connected to the for Arduino's high-resolution dedicated timer - no jitter!
02. Can drive 4 for DC motors or 2 stepper motors or 2 Servo
Up to 4 bi-directional for DC motors with individual 8-bit speed selection
03. Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
04. 4 H-Bridges: per bridge provides 0.6A (1.2A for peak current) with thermal for protection, can run motors on 4.5V to 36V for DC
Pull down resistors keep motors disabled during power-up
for Arduino reset button
05. 2 external terminal power interface, for seperate logic/motor supplies
06. compatible with for Arduino
