Using L298N made by ST company as the control chip, the module has such characteristics as strong driving
ability, low1.Double H bridge drive
2.Chip: L298N
3.Logical voltage: 5V
4.Drive voltage: 5V-35V
5.Logical current: 0mA-36mA
6.Drive current: 2A(MAX single bridge)
7.Max power: 25W
8.Size:43 x 43 x 26mm
9.Net weight: 26g
Note:
*This module has a built-in 5v power supply, when the driving voltage is 7v-35v, this supply is suitable for power supply
*DO NOT input voltage to +5v supply interface, however ledding out 5v for external use is available.
*When ENA enable IN1 IN2 control OUT1 OUT2
*When ENB enable IN3 IN4 control OUT3 OUT4 calorific value and strong anti-interference ability.
I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
01. 2 interface for 5V Servo connected to the for Arduino's high-resolution dedicated timer - no jitter!
02. Can drive 4 for DC motors or 2 stepper motors or 2 Servo
Up to 4 bi-directional for DC motors with individual 8-bit speed selection
03. Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
04. 4 H-Bridges: per bridge provides 0.6A (1.2A for peak current) with thermal for protection, can run motors on 4.5V to 36V for DC
Pull down resistors keep motors disabled during power-up
for Arduino reset button
05. 2 external terminal power interface, for seperate logic/motor supplies
06. compatible with for Arduino
Signal input: single ended, pulse / direction
Subdivision optional: 1/2/4/8/16/32 subdivision
Output current: 0.5A-4.0A
Input voltage: 9-42VDC ( Optimal： 12-30VDC )
The current is automatically halved at rest.
TB6600 Can drive 4, 6 and 8 Lead two-phase, four-phase stepper motor
Optocoupler isolated signal input, strong anti-interference ability,
With overheating, overcurrent, undervoltage lockout, input voltage anti-reverse protection and other functions
Small size, easy to install
External signal 3.3-24V universal, no series resistor required
Operating Temperature: -10 to 45 Degrees Celsius
Storage temperature: -40 to 70 Degrees Celsius
Chopping Frequency: less than 50KHZ
Features:
This is THE BEST 30A ESC for multirotor
This hardware, with the SimonK firmware, gives you the perfect solution for multirotor use
Highest efficiency 100% N-FET design.
Highest accuracy with Crystal Oscillator (Temperature won't affect the PWM operating range like other cheap ESC's).
the maximum current of 2.5A.
the maximum support 32 subdivision.
4 layer PCB board, better heat dissipation.
the chip resistance is smaller, lower heat, better heat dissipation.
Description
16 v Voltage Max:
Maximum current rating: 30 A
Practical Continuous Current: 14 A
The Current sensing available analog pin
MOSFET on - hold: 19 m Ω (per legs)
Maximum PWM frequency: 20 kHz
Thermal Shutdown
Undervoltage and Overvoltage shutdown
