1. 3v-5v voltage available
2. Type: GY-GPS6MV2
3. With ceramic antenna, the signal is strong
4. EEPROM save configuration parameter data when power supply drop
5. Data backup battery
6. LED signal lights
7. Default baud rate: 9600
The HC-05 bluetooth module can be set as a transmitter or receiver. You can combine this bluetooth module with your system: MCU, ARM or DSP systems, SOC systems.
This module can build a connection to other modules in two ways: as a master or as a slave. Ex, a robot can be designed to be a master connected to a slave bluetooth module or as a slave board to make a wireless connection with a PC.
Features:
1.100% Brand new and high quality
2.Adopt imported controller PL2303HX,which can stabilize the flash with high speed
3.500mA self recovery fuse for protection
4.Two data transmission indicator can monitor data transfer status in real time
5.Reserve 3.3V and 5V pin interface,easy for the DDWRT of different voltage system that need power
6.Electrostatic package,insures the board will not be damaged before use
7.Support WIN7,Win8,Vista,XP system
Package Included:
1 x PL2303HX module
Specification
1.Works with standard (dual 5/3.3V) and 3.3V-only (for example, Arduino Pro)boards.
2.Operates over the extended -40°C to +85°C temperature range
3.Complies with USB Specification Revision 2.0 (Full-Speed 12Mbps Peripheral,
4.Full-/Low-Speed 12Mbps/1.5Mbps Host)
Parameters:
PCB Dimensions: 26.5* 15.6mm
With 3.3V and 5V dual power output
With three LEDs: power indicator, data reception indicator, the data transmission indicator, working status
With self-recovery fuse. In the event of accidental short circuit, it can effectively protect your computer USB port and Downloader
With reset signal output, etc. directly to the for Arduino board Promini download!
Features:
1. Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications.
2. 125 Channels, Multi-point communication and frequency hopping to meet the communication needs
3. Built-in hardware CRC error detection, Multipoint communication address control.
4. Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
5. Built-in 2.4Ghz antenna
6. Available software to set the address, only received local Address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers, Software programming is very convenient.
7. Built-in voltage regulator
8. Standard DIP Pitch Interface for embedded applications
9. size: 34mm X 17mm X 1mm
Package Included:
1 xArduino NRF24L01+ 2.4GHz Wireless Transceiver Module
Specification:
USB to serial converters, including CDC ACM, Prolific PL2303 and FTDI FT232
Google ADK v.1
PTP with Canon EOS and Powershot extensions, as well as Nikon DSLR cameras