The Flame Sensor can detect flames in the 760 – 1100 nano meter wavelength range. Small flames like a lighter flame can be detected at roughly 0.8m. Detection angle is roughly 60 degrees and the sensor is particularly sensitive to the flame spectrum. An on board LM393 op amp is used as a comparator to adjust the sensitivity level. The sensor has a digital and analog output and sensitivity can be adjusted via the blue potentiometer.
Specifications
On-board MT8870 frequency decoder chip
On-board audio input interface
On-board LED lights for output state indication
PCB Size: 26.5 x 24.5 mm
WIDE SUPPLY RANGE: 2.0V to 5.5V
LOW CURRENT CONSUMPTION: Continuous Mode: Only 150A Single-Shot Mode: Auto Shut-Down
PROGRAMMABLE DATA RATE: 8SPS to 860SPS
1 single module can drive the an 8 * 8 dot matrix common cathode
2 the module Operating voltage: 5 v
The Module 3 dimensions: length 3.2 cm X 3.2 cm wide X 1.3 cm high
4 holes with four screws, the diameter of 3 mm
Range of Receiving Frequency - 1575.42MHz
Band Width(MHz) - 10MHZ
Gain (Zenith)(dBi typ) - 0dB
Gain(10°elevation) -5dB
Polarization - Right-Handed Circular
Impedance(O) - 50%O
coil rated voltage : 12V
Rated Load: 10A 250VAC, 10A 30VDC
Max Switching Current: 10A
Max Switching Voltage: 110VDC / 250VAC
Coil power 0.45W
Contact Arrangement: C:1 (NO/NC)
Dimensions: 19 x 15 x 15 mm