For minimum of Rs 1500 orders are delivered with Free. Other orders are charged delivery charge by delivery partners
Sold out
Arduino Leonardo R3
LKR 1,590.00
Microcontroller:ATmega32u4
Operating Voltage:5V
Input Voltage (recommended):7-12V
Input Voltage (limits):6-20V
Digital I/O Pins:20
PWM Channels:7
Analog Input Channels:12
DC Current per I/O Pin:40 mA
DC Current for 3.3V Pin:50 mA
Flash Memory:32 KB (ATmega32u4) of which 4 KB used by bootloader
SRAM:2.5 KB (ATmega32u4)
EEPROM:1 KB (ATmega32u4)
Clock Speed:16 MHz
Length: 68.6 mm
Width: 53.3 mm
Weight: about 20g
Out of stock
Related products
Nano Terminal Adapter Expantion Board
This is a terminal adapter for the for arduino Nano.
It lables for arduino Nano version 3.0,
however you can still use this adapter for the older version
(just have to remember that A0-A7 are in the reverse order).
You can use this adapter to easily hook up for arduino Nano to an outside world via hook up wires.
Board Size:5.2x3.5cm(approx)
Nano Terminal Adapter with DC Power Supply
AREF Output: 3.3V
Expand all 6 PWM pins
Expans I2C pins
Compatible only with Arduino NANO
Expand DC power interface
Available pins: +3.3V, +5V, GND, I2C, RX/TX, All other IOs
WIFI Module ESP8266 ESP 01
SDIO 2.0, SPI, UART 32-pin QFN package Integrated RF switch, balun, 24dBm PA, DCXO, and PMU Integrated RISC processor, on-chip memory and external memory interfaces Integrated MAC/baseband processors Quality of Service management I2S interface for high fidelity audio applications On-chip low-dropout linear regulators for all internal supplies Proprietary spurious-free clock generation architecture Integrated WEP, TKIP, AES, and WAPI engines Solutions
Supports APSD for optimal VoIP applications
Patented spurious noise cancellation algorithm for integration in SOC applications
Supports Bluetooth co-existence interface
Self-calibrated RF to ensure optimal performance under all operating conditions
Zero factory tuning
No external RF components
Specifications
802.11 b/g/n
Wi-Fi Direct (P2P), soft-AP
Integrated TCP/IP protocol stack
Integrated TR switch, balun, LNA, power amplifier and matching network
Integrated PLLs, regulators, DCXO and power management units
+19.5dBm output power in 802.11b mode
Power down leakage current of <10uA
Integrated low power 32-bit CPU could be used as application processor
SDIO 1.1/2.0, SPI, UART
STBC, 1×1 MIMO, 2×1 MIMO
A-MPDU & A-MSDU aggregation & 0.4ms guard interval
Wake up and transmit packets in < 2ms
Standby power consumption of < 1.0mW (DTIM3)
USB to ESP8266 WIFI module adapter
This module is only USB serial port module, is responsible for converting the USB interface into the ESP8266 module serial port. WiFi knowledge of all aspects of the query module ESP8266 related information!!
LilyPad ATTINY85
Programmable with on-board USB port and the free Arduino IDE
Great for wearables, textile projects - combine with any LilyPad sensor, power supply and LEDs
Only 25mm in diameter!
8K Byte of In-System Programmable Program Memory Flash,
512 Bytes In-System Programmable EEPROM /512 Bytes SRAM