2G 3G IPEX antenna
Connector type: ipx13
In the definition of Bobbi: S.W.R <= 1.8
Gain definition: 3dBi (*Typical*)
Frequency band definition: 1710~2170MHz 800~960
Impedance definition: 50 ohm
Total length: as shown in Figure
Electrical Characteristics A.
S.W.R. 3 @ MHz & 880~960
<=2.5 @ MHz 1710~1800
Impedance 50 Ohm
Features:
1. Maximum operating speeds up to 2Mbps, GFSK modulation efficiency, Anti-interference ability, Particularly suitable for industrial control applications.
2. 125 Channels, Multi-point communication and frequency hopping to meet the communication needs
3. Built-in hardware CRC error detection, Multipoint communication address control.
4. Low-power 1.9 ~ 3.6V, only 1uA on Power down mode
5. Built-in 2.4Ghz antenna
6. Available software to set the address, only received local Address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers, Software programming is very convenient.
7. Built-in voltage regulator
8. Standard DIP Pitch Interface for embedded applications
9. size: 34mm X 17mm X 1mm
Package Included:
1 xArduino NRF24L01+ 2.4GHz Wireless Transceiver Module
Specification:
* Quad-Band 850 / 900/ 1800 / 1900 MHz - would work on GSM networks in all countries across the world.
* GPRS multi-slot class 10/8
* GPRS mobile station class B
* Compliant to GSM phase 2/2+
* Class 4 (2 W 850 / 900 MHz)
* Class 1 (1 W 1800 / 1900MHz)
1. 3v-5v voltage available
2. Type: GY-GPS6MV2
3. With ceramic antenna, the signal is strong
4. EEPROM save configuration parameter data when power supply drop
5. Data backup battery
6. LED signal lights
7. Default baud rate: 9600
Features:
1.100% Brand new and high quality
2.Adopt imported controller PL2303HX,which can stabilize the flash with high speed
3.500mA self recovery fuse for protection
4.Two data transmission indicator can monitor data transfer status in real time
5.Reserve 3.3V and 5V pin interface,easy for the DDWRT of different voltage system that need power
6.Electrostatic package,insures the board will not be damaged before use
7.Support WIN7,Win8,Vista,XP system
Package Included:
1 x PL2303HX module
Description
With this Ethernet Shield, your Arduino board can be used to connect to internet.
Can be used as server or client.
Directly plug puzzle board, no soldering required.
Controller: W5100.
This Arduino Ethernet Shield which is based on the Wiznet W5100 Ethernet Chip gives you an easy way to get your Arduino Online.
It is directly supported by Arduino official Ethernet Library.
