
with professionals


with pi zero




Shaft Coupling 5mm
Material: brass
Inner diameter: 2/4/5/6/7mm
Hexagon side length: 7mm
Diagonal distance: 13.6mm
Distance across flat: 12mm
Total height: 18mm
Cylinder part height: 12mm
Out diameter of cylinder part: 11mm
USB to R232 TTL Converter
Features:
1.100% Brand new and high quality
2.Adopt imported controller PL2303HX,which can stabilize the flash with high speed
3.500mA self recovery fuse for protection
4.Two data transmission indicator can monitor data transfer status in real time
5.Reserve 3.3V and 5V pin interface,easy for the DDWRT of different voltage system that need power
6.Electrostatic package,insures the board will not be damaged before use
7.Support WIN7,Win8,Vista,XP system
Package Included:
1 x PL2303HX module
ESC speed controller
Features:
This is THE BEST 30A ESC for multirotor
This hardware, with the SimonK firmware, gives you the perfect solution for multirotor use
Highest efficiency 100% N-FET design.
Highest accuracy with Crystal Oscillator (Temperature won't affect the PWM operating range like other cheap ESC's).
Metal Gear Servo Motor MG90S
01. Weight : 13.6G
02. Dimension : 22.8mm x 12.2mm x 28.5mm
03. Stall Torque : 1.8kg/cm(4.8V )2.2kg/cm(6V)
04. Temperature Range : 0 degree to 55 degree
05. Operating Speed :
06. 0.1sec/60degree(4.8v),0.08sec/60degree(6v)
07. Dead Band Width : 5 usec
08. Operation Voltage : 4.8 - 6Volts
09. Operating torque: 2KG/cm
10. servos Type : Digital servo
11. Gear Type : All Metal gear
12. Plug Type :JR FUTABA
13. structural materials: Metal gear Coreless Motor DUAL BALL Axle Bearing
Lithium Battery Capacity Indicator 1S 3.7V
Features:
1.Battery type electricity quantity display
2.Wide application fields:lithium battery
3.Using Method:connect display board positive and negative port with tested battery positive and negative port,digital tube will display real-time battery electricity quantity
4.Digital Color:outline red,display block blue (when battery electricity quantity is full,it will be all on)
LED 7 Segment 4 digit Red 0.4
- 4 bit Common Cathode Digital Tube 0.4" 0.4in. Red LED Display 7 Segment
LilyPad ATTINY85
Programmable with on-board USB port and the free Arduino IDE
Great for wearables, textile projects - combine with any LilyPad sensor, power supply and LEDs
Only 25mm in diameter!
8K Byte of In-System Programmable Program Memory Flash,
512 Bytes In-System Programmable EEPROM /512 Bytes SRAM
Resistors
Carbon Film Resistor 0.125W 5%
Flex Sensor 2.2″
Flat Resistance: 10K Ohms ±30%
Bend Resistance: minimum 2 times greater than the flat resistance at 180° pinch bend
Power Rating : 0.5 Watts continuous; 1 Watt Peak
Life Cycle: >1 million
Height: 0.43mm (0.017")
Temperature Range: -35°C to +80°
FEATURED
18650 1200mAh 3.7V Li-ion Rechargeable Battery
Nominal Voltage 3.7V
Charge Voltage 4.2V
Cut-off Voltage 2.75V
Capacity 1200mAh
Diameter 18.4mm
Height 65.0mm
Temperature Charge: 0°C ~ 45°C
Discharge: -20°C ~ 60°C
Storage: -20°C ~ 30°C
Humidity: 65±20%
Cycle life >500 times
Standard charge current 0.5C
Fast charge current 1C
Max discharge current 1C
OEM customize wires/connector/solder tabs/battery packs
Packing traying packing or in small boxes
Certificate CE, ROHS, MSDS
18650 3200mAh 3.7V Li-ion Rechargeable Battery
Nominal Voltage 3.7V
Charge Voltage 4.2V
Cut-off Voltage 2.75V
Capacity 1800mAh
Weight 44g
Diameter 18.4mm
Height 65.0mm
Temperature Charge: 0°C ~ 45°C
Discharge: -20°C ~ 60°C
Storage: -20°C ~ 30°C
Humidity: 65±20%
Cycle life >500 times
Standard charge current 0.5C
Fast charge current 1C
Max discharge current 1C
OEM customize wires/connector/solder tabs/battery packs
Packing traying packing or in small boxes
Certificate CE, ROHS, MSDS
AC Digital Amp Volt Meter 100A 300V
Features:
* Dual measurement of AC voltage, AC current with AC current transformer
* Voltage Measuring Range: AC 80 ~ 300V
* Current Measuring Range: AC 0.1 ~ 100A (Current in excess of 1A is recommended)
* Display backgroud color & Type: Blue & LCD
NEW ARRIVALS
ඔබගේ video Tutorials / තාක්ෂණික ලිපි මෙහි පළකර ගැනීමට අපවෙත යොමු කරන්න
Brands
[contact-form-7 id=”7″]