with professionals
with pi zero
USB toTTL CP2102 Converter
Parameters:
PCB Dimensions: 26.5* 15.6mm
With 3.3V and 5V dual power output
With three LEDs: power indicator, data reception indicator, the data transmission indicator, working status
With self-recovery fuse. In the event of accidental short circuit, it can effectively protect your computer USB port and Downloader
With reset signal output, etc. directly to the for Arduino board Promini download!
GPS GSM Tracker MS-TX5
Features:
Real time location tracking, track playback.
Support SMS and GPRS platform tracking.
Built-in vibration senor, the realization of vehicle vibration alarm.
Micro letter management platform, free control.
Mobile client support android, apple system remote control.
Compass 3 Axis Accelerometer + 3 Axis Magnetometer Module LSM303DLHC GY-511 Module
Model: GY - 511
Size: 14.5 mm * 20.5 mm
Name: LSM303DLHC module (triaxial magnetic field + triaxial acceleration)
Use chip: LSM303DLHC
Power supply: 3-5v (internal low voltage differential regulator)
Communication mode: standard IIC communication protocol
Magnetic field range: ±1.3 /± 1.9 /± 2.5 /± 4.0 /± 4.7 / 5.6 mm / 8.1 mm gauss
Acceleration range: ±2 g/±4 g/±8 g
18650 1200mAh 3.7V Li-ion Rechargeable Battery
Nominal Voltage 3.7V
Charge Voltage 4.2V
Cut-off Voltage 2.75V
Capacity 1200mAh
Diameter 18.4mm
Height 65.0mm
Temperature Charge: 0°C ~ 45°C
Discharge: -20°C ~ 60°C
Storage: -20°C ~ 30°C
Humidity: 65±20%
Cycle life >500 times
Standard charge current 0.5C
Fast charge current 1C
Max discharge current 1C
OEM customize wires/connector/solder tabs/battery packs
Packing traying packing or in small boxes
Certificate CE, ROHS, MSDS
Distribution Board Battery ESC
Specification: * Material: glass fiber * Color: Blue * Compatible with MK KK Flight control bolt Center * Compatible with MK KK RC helicopter * Can connect 1 * 8 ESC * Size:5cm * 5cm * 0.2cm * Weight:15g
Current Sensor Module ACS712 (5A)
1. The current sensor chips: ACS712ELC-05B.
2. pin 5V power supply, on-board power indicator.
3. the module can be measured plus or minus 5 amps, corresponding to the analog output of 185 mV / A.
4. there is no the detection current through, the output voltage is VCC / 2.
5. PCB board size: 31 (mm) x13 (mm).
Note: ACS712 Hall detection principle, when you use to avoid magnetic field impact this!
Solar Panel Cell 5.5V 50mA
5.5V 50mA Solar Panel Mini Polysilicon Solar Epoxy Plate Battery
Arduino Mega R3
The Mega 2560 is an update for the Arduino Mega, which it replaces.
The board is a microcontroller board based on the ATmega2560-16AU .It has 54 digital input/output pins (of which 14 can be used as PWM outputs), 16 analog inputs, 4 UARTs (hardware serial ports), a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with a AC-to-DC adapter or battery to get started. The Mega is compatible with most shields designed for the Arduino Duemilanove or Diecimila.
CH340G replace the Atmega 8U2/16U2
CH340G Driver Download link, please copy the link and paste in browser: http://www.5v.ru/ch340g.htm
Microcontroller:ATmega2560
Clock Speed:16 MHz
EEPROM:4 KB
SRAM:8 KB
Flash Memory:256 KB of which 8 KB used by bootloader
Operating Voltage:5V
Input Voltage (recommended):7-12V
Analog Input Pins:16
Digital I/O Pins:54 (of which 14 provide PWM output)
DC Current for 3.3V Pin:50 mA
DC Current per I/O Pin:40 mA
Propeller 60mm Diameter four-leaf
diameter:600mm
hole diameter:1.9mm for 2mm shaft
weight:2g
Wireless Tranciever NRF 21L01+ Antena
Specifications : * Voltage: 3-3.6V (recommended 3.3V) V * Maximum output power: +20dBm * Emission mode current(peak): 115Ma * Receive Mode Current(peak): 45Ma * Power-down mode current: 4.2Ua * Sensitivity 2Mbps mode in received: -92dBm * Sensitivity 1Mbps mode in received: -95dBm * Sensitivity 250kbps mode in received: -104dBm * PA gain: 20Db
දැන් Arduinoshop.lk ඔබේ අතේ දුරට.
6MB පමණයි.
FEATURED
18650 1200mAh 3.7V Li-ion Rechargeable Battery
Nominal Voltage 3.7V
Charge Voltage 4.2V
Cut-off Voltage 2.75V
Capacity 1200mAh
Diameter 18.4mm
Height 65.0mm
Temperature Charge: 0°C ~ 45°C
Discharge: -20°C ~ 60°C
Storage: -20°C ~ 30°C
Humidity: 65±20%
Cycle life >500 times
Standard charge current 0.5C
Fast charge current 1C
Max discharge current 1C
OEM customize wires/connector/solder tabs/battery packs
Packing traying packing or in small boxes
Certificate CE, ROHS, MSDS
18650 3200mAh 3.7V Li-ion Rechargeable Battery
Nominal Voltage 3.7V
Charge Voltage 4.2V
Cut-off Voltage 2.75V
Capacity 1800mAh
Weight 44g
Diameter 18.4mm
Height 65.0mm
Temperature Charge: 0°C ~ 45°C
Discharge: -20°C ~ 60°C
Storage: -20°C ~ 30°C
Humidity: 65±20%
Cycle life >500 times
Standard charge current 0.5C
Fast charge current 1C
Max discharge current 1C
OEM customize wires/connector/solder tabs/battery packs
Packing traying packing or in small boxes
Certificate CE, ROHS, MSDS
AC Digital Amp Volt Meter 100A 300V
Features:
* Dual measurement of AC voltage, AC current with AC current transformer
* Voltage Measuring Range: AC 80 ~ 300V
* Current Measuring Range: AC 0.1 ~ 100A (Current in excess of 1A is recommended)
* Display backgroud color & Type: Blue & LCD
NEW ARRIVALS
ඔබගේ video Tutorials / තාක්ෂණික ලිපි මෙහි පළකර ගැනීමට අපවෙත යොමු කරන්න
තාක්ෂණික ලිපි කියවන්න
November 29, 2019
ICT – A/L Micro-controller Development Systems ක්ෂුද්ර- සකසන සංවර්ධන පද්ධති කොටස – 01
Micro-controllers and micro-processors ක්ෂුද්ර-පාලක සහ ක්ෂුද්ර-සකසන සාමන්ය පුද්ගල පරිගනකයක් සැලකූවිට එය ප්රධාන කොටස් කිපයකින් සමන්විත බව අපි දන්නවා එවා නම්
October 17, 2019
Micro-controller Development Systems ක්ෂුද්ර-සකසන සංවර්ධන පද්ධති කොටස – 03
අපි දැන් සංවර්ධිත පුවරුව පරිගනකය හා සම්බන්ද කිරීම, ක්රමලේකනය හා කෙතය උඩුගත කිරිම සම්බන්දයෙන් සලකා බලමු. Arduino Uno / Mega සංවර්දිත
November 30, 2018
Micro-controller Development Systems ක්ෂුද්ර-සකසන සංවර්ධන පද්ධති කොටස – 02
ක්රමලේකනය (program) කිරිමට සහ ක්රියත්මක විමට අවශ්ය මුලිකාංග ඇතුලත් කර සංවර්ධන පුවරු සහ සංවර්ධන පද්ධති නිර්මාණය කර ඇත. වඩාත් ප්රසිද්ධ
Brands
[contact-form-7 id=”7″]